- VCF South West - June 14 - 16, Davidson-Gundy Alumni Center at University of Texas at Dallas
- VCF West - Aug 2 - 3, Computer History Museum, Mountain View, CA
- VCF Midwest - Sept 7 - 8 2024, Schaumburg, IL
- VCF SoCal - Mid February 2025, Location TBD, Southern CA
- VCF East - April 2025, Infoage Museum, Wall NJ
-
Please review our updated Terms and Rules here
Gary C's latest activity
-
Gary C replied to the thread Desoldering technique.Non-corrosive desoldering flux can be very helpful at making sure oxidised solder melts and flows without excess heat application Use... -
Gary C replied to the thread Whats the purpose of this jumper on this ieee-488 adapter?.Oh yes :)
-
Gary C reacted to dave_m's post in the thread Whats the purpose of this jumper on this ieee-488 adapter? with
Like.
Gary, That is correct, but note that the /Reset signal is not inverted (the 7417 is a non-inverting buffer). The /IFC is also a LOW... -
Gary C replied to the thread Whats the purpose of this jumper on this ieee-488 adapter?.It inverts reset so when the PET gets a reset, the interface clear line is pulled and all devices no matter what they are doing...
-
Gary C replied to the thread Whats the purpose of this jumper on this ieee-488 adapter?.I imagine the pin connected to nowhere is so you can store the jumper from red to ? when not in use.
-
Gary C replied to the thread It seems that I cannot have an Archimedes..With a RISC OS machine, have you tried holding down delete when powering it up ? It will reset the video to mode 0 15kHz.
-
Gary C replied to the thread Cromemco dazzler replica project.Corrections are all updated on Github but they were. IC 43 pins 10,13 & 14 - connect to adjacent rail - fixed IC 39 pin 14 - connect to...
-
Gary C replied to the thread Cromemco dazzler replica project.Just a note to point out I still have two sets of boards available if anyone wants them They would need the minor errors found...
-
Gary C replied to the thread I guess its that time of year again....Must be nice to have so much space ! :)
-
I guess I have to make one of those "Equipped with DAZZLER" labels now! :)
-
Gary C replied to the thread Cromemco dazzler replica project.and iiiiiiiiii have become comfortably numb... epic. Good choice.
-
I think that is the speed K.Scope was supposed to run at, it has that Mesmerizing quality to it, possibly would be good with Pink...
-
Gary C replied to the thread Cromemco dazzler replica project.Oddly, I had already changed it to 7408 even though I put 7403 in the post.
-
Congratulations, this has been a great team effort. I'll update also the Rev D version. @Gary C: Small correction of your...
-
Gary C replied to the thread Cromemco dazzler replica project.Given the note in the Northstar manual about using their Dynamic RAM with the Dazzler after a modification then I might have a go at...