ohmylove2u's latest activity

Yes, it is correct! The tantalum capacitors on my 5162 are shown below. I had to replace all of them.

Finally, I upgraded the motherboard bios with AMI version. Everything works fine.

Out of curiosity I picked up one of the similar terminals that have been listed on yahoo recently. As expected, the floppy drive was...

The frequencies and waveforms are as follows: PIN 6: GND PIN 7 : PIN 4: PIN 5: I think it should show something. Any suggestion?

Hello everyone, This time I want to share my experience with a T1200 repair/restoration project. I bought the laptop from eBay, it was a...

Despite my attempts at various combinations, but I failed again! Looks like I had to buy an old IBM monitor. （input signal out of rang）

Yes. It has a floppy drive. At the moment I have neither a keyboard nor software. The first thing I want to do is make it display something.

I just disassembled it again! I think only three signal lines are useful. If they correspond to RGB signals, then there is no h-sync &...

China is where I'm located. After studying the relevant [docs], I can sure that the 8pin din is a connector for monitor. I found a...

I will follow the instruction. Thanks!

The third link at [here] points to an example of an XUB upgrade procedure.

I got this IBM 5295G by $70. The only documentation I could find was on this Japanese site. It’a on line terminal. It seems to be...

I’m waiting for the programer. When I got it ,I will try your way. Thanks a lot!

I got one. It works fine. BTW,I just replaced the connector of the keyboard with a couple of DB9 connector :)

I haven't purchased a card of this kind yet. Because I'm not sure if an IDE hard drive can be used with this vintage IBM computer.