RichCini's latest activity

I've been contacted a few times about these, so here they are. They are raw disk image read/write utilities from Microsoft. Unsure of...

Thanks Larry. The author said to me that his emulator supports only the 4FDC, so I suspect the images I happen to be trying to use from...

Unfortunately I don't have my imaging setup setup so I can't test it. What I can say from using IMDV on those images is that its a...

Will do. I just grabbed a version of CDOS 2.58 from Dave Dunfield's site, converted it, and it ran just fine. It must be an issue with...

No, I didn't examine it yet. Let me do that. Looks like Track 0 is also MFM 512 bytes rather than FM 128 bytes and the chromix header...

Yes, with and without the /E parameter. The file size that is produced (1182720) does not match the size of the flat file provided by...

All -- I'm attempting to use a Cromemco emulator (https://www.sydneysmith.com/wordpress/run-cdos/) as part of some work I'm doing with...

It's me that's working with @new_castle_j on the reproduction board. I received the first run boards about 2 weeks ago, but had to trash...

There are some problems with the boards so I have to scrap them. Since I have to re-do the boards, I’m going over the schematic redraw...

I should note that I replaced the LM338K and LM317 adjustable regulators with the fixed equivalents and the associated resistors...

No. I used a single chip with A13. I’m hoping that actually works. Design-wise that’s the only thing different.

Boards arrived today. Just ordered parts -- it's an expensive board to populate.

Yes I probably should, good point. Lots of stuff there aside from Lomas but here’s the Lomas link. https://github.com/RichCini/LomasBoards

I’m not producing ready-to-run boards but the design files and PAL/ROMs are posted on my GitHub. I may have a limited blank board run...

Larry -- if you're looking only for the source files, they're in the "src_v2" archive. For the binaries, you need to use the process Pig...