Search results

I've been in conversation on Facebook group "DEC Computer Users" with someone giving away a PDP-11/34 in UK. He sent me some photos today but is in too bad a condition for me to want it. It looks to have a complete PCB set to me. With DL11, DL11-W, RX11 and RK11. So if anyone is interested and...

Hi, No. I'm not the same PG.

Unfortunately I don't have the schematic, here are some images of my BA11-VA from previous posts,

I looked after several 11/70's in late 80's to early 90's running RSX-11m. After any odd failures we would run IOX (I/O exerciser) that was on the RSX-11m boot disk.

The 9 pin connections are the standard 11/93 back panel ports for serial and a 25 pin serial console. The bottom right is DEQNA ethernet and the bottom left is SCSI. The system must have had or has a SCSI controller for the TZ30 tape drive in the front of the system

Just spotted these on Epay...

Have you tried Keaterm?

May be of interest to UK and beyond collectors, https://www.ebay.co.uk/itm/115811150665 https://www.ebay.co.uk/itm/115811151888 I have no connection with the seller.

How about a Qbone, to emulate disk storage? http://retrocmp.com/projects/qbone/313-qbone-introduction

These usually come in a BA400 enclosure that may contain some DSSI disks and a TQK70 tape drive. Can you post some photos of the inside front so we can see what controllers it has and if it has any storage?

Hi, Maybe take a look in the DEC specific forum and possibly re-post https://forum.vcfed.org/index.php?forums/dec/

I'm not sure if you are planning on using the DHV11 to obtain console port, don't think it is supported?

DEC measuring stick (there are no markings on the IC )

Teletech, slightly off topic but...in your second photo the keyboard is sitting on top of either a BA11-VA or a TU58 drive (possibly something else!) I have a BA11-VA based 11/02 running RT-11, I'd be interested to know what you are doing with yours, perhaps in a new thread. Thanks.

Hi ethump, glad to here another DEC MIPS machine is working. That's three I know of in north of England. I haven't looked at OSF yet.

Are two terminators necessary/supported in the 11/05? I see two in the above photos. Perhaps as also previously suggested you cant try terminating at the end of the first backplane, that will eliminate the issue being in the other two backplanes.

Thanks g4ugm for the offer but I think I've made good progress. I dug out an NEC SCSI CD-ROM drive and while looking in the box I found a DEC RRD43, I've previously only tried known good working RRD42 drives from my VAXstations's. I connected up the NEC drive and attempted to boot (boot...

Thanks, I'll dig a more modern SCSI CD-ROM out and give that a try. I've tried a couple of RRD42 already.

I have been struggling to burn the Ultrix images to CD-R but after a lot of trial and error and testing I've managed to burn both a 4.3 and a 4.5 iso. I used UltraISO but had to throttle back the write speed of my writer from 24x to 4x. I can now boot both the 4.3 CD and 4.5 CD but after...

Thanks MattisLind for the information.