I'm Looking to build a PETDISK SD interface based on Gubbish's Design :)

waltermixxx · Sep 26, 2016

looking to build one based on: http://www.bitfixer.com/bf/wp-content/uploads/2011/09/PETdisk_schematic.jpg

but would like to substitute with an Atmega328 arduino chip.

Wondering if anyone has done this

and may have the code to burn into the atmega.

I like hardware soldering etc, but not great with programming and adapting code.

cheers.

waltermixxx · Sep 29, 2016

Managed to get a full kit from a friend, so this evening i will solder up the board,
and try it out. I will update to the latest 3.0 firmware.

cheers.

waltermixxx · Oct 1, 2016

Updated to the latest firmware... and the unit works as advertised it allows one to run prg programs etc.

I like it's simplicity.

But I'm still very tempted to get one of these: http://blog.tynemouthsoftware.co.uk/2015/05/pet-microsd-commodore-pet-sd-card-disk.html
it seems like a polished device, and the creator of it is readily available via email