snq
Experienced Member
I got myself some new network cards, but obviously didn't bother to check the system requirements before I bought them. It says a 386 is required but I have a 286..
I found a packet driver for it which says I need to run the configuration utility, which just hangs my AT. A disassembly showed me that the config utility uses 32 bit registers every now and then so I guess that explains that.
I'm hoping that the packet driver itself will do with a 286 but I need some way to configure it. Or at least figure out what the packet driver wants before it'll accept the current configuration.
Any ideas?
I found a packet driver for it which says I need to run the configuration utility, which just hangs my AT. A disassembly showed me that the config utility uses 32 bit registers every now and then so I guess that explains that.
I'm hoping that the packet driver itself will do with a 286 but I need some way to configure it. Or at least figure out what the packet driver wants before it'll accept the current configuration.
Any ideas?