• Please review our updated Terms and Rules here

Need a Terminator Pack for a TRS 80 Model II

Could you picture some ham-handed businessman opening up the model two and removing the termination jumpers so he could use the new Drive Expansion Bay he just bought?

Much easier to have a little plug-in to remove and just plug the cable from the expansion box in.

I'm tending to agree with you.
Opening the case isn't the PITA part - it's getting at the termination jumpers that is.
You either take the whole drive out to get at the area the jumpers are located, or you screw around for 15 minutes with needle nose pliers trying to do it with the drive in place.

I think the later DC board with no external termination and no wire wrap jumpers required, was a much better solution.
 
Back
Top