spiceminer
Experienced Member
Dear All!
Since a few years I own a Nixdorf Quattro/7 that I rescued from a haystack.
Unfortunately it will not boot.
When I try to start the machine, I get following codes on the status display:
FF
E0
B0
1 - in parallel to this some 2 seconds seeking noise from the hard drive
followed by 43/C0 in an endless loop.
No difference if a terminal is connected or not.
The machine has the CPU, 4x ALME and the HD Controller card.


I assume the error is related to a faulty harddrive.
Is there possibly some disk image (hard disk or floppy) available to boot or diagnose the machine any further?
Thanks a lot and best regards
Stephan
Since a few years I own a Nixdorf Quattro/7 that I rescued from a haystack.
Unfortunately it will not boot.
When I try to start the machine, I get following codes on the status display:
FF
E0
B0
1 - in parallel to this some 2 seconds seeking noise from the hard drive
followed by 43/C0 in an endless loop.
No difference if a terminal is connected or not.
The machine has the CPU, 4x ALME and the HD Controller card.


I assume the error is related to a faulty harddrive.
Is there possibly some disk image (hard disk or floppy) available to boot or diagnose the machine any further?
Thanks a lot and best regards
Stephan