PCB fixture/holder

[DeltaDon]

I'm making up some 100mm2 SMD boards and I needed a larger board holding device than what I own. I looked on Amazon and eBay for what I was hoping to find and nothing seemed to be available and in my price range. Or at least marketed as a PCB holder. I did find something that would work for my needs being sold as a CNC Router clamp. It's made by Genmitsu and is a very well made machinist vice made with aluminum jaws that have cutouts that allow the PCB to sit on both jaws. The jaws open to 5.7" (145mm). Found on Amazon.

 

[Uniballer]

Is Panavise 315, 324, 333 out of range? Works with any Panavise 300-series base if you already have one.

What about PANAVISE 350 Multi-Purpose Work Center

 

[DeltaDon]

Thanks for the suggestion and most likely not out of my range if I found a used one, but I already purchased the Genmitsu. Plus I can use the Genmitsu (hopefully) with my mini mill and/or drill press.