Hello,
I am trying to format st225 and st251 connected to RQDX3 through M9058 but I'm getting error:
controller has reported a fatal error in the format program
status: rct write error
what I should check to get an idea about the cause of this error?
thanks,
Andrey
p.s. also I have couple of rqdx1(2?) cards, what drives they would support provided latest firmware is installed?
I am trying to format st225 and st251 connected to RQDX3 through M9058 but I'm getting error:
controller has reported a fatal error in the format program
status: rct write error
what I should check to get an idea about the cause of this error?
thanks,
Andrey
p.s. also I have couple of rqdx1(2?) cards, what drives they would support provided latest firmware is installed?