SIP bussed resistor array with common pin centered

[maxtherabbit]

I have a Mitsubishi floppy drive which used a SIP terminator that is a bussed resistor network, but the common is the center pin. All modern bussed resistor arrays seem to have the common as pin 1. Is there a different name for this type of configuration or are these just no longer made that way?

 

[alank2]

I've never seen one with a common pin in the center for a bussed resistor network, but I've only been using them for 10-15 years.

 

[Chuck(G)]

I'd call it "custom"

 

[Dwight Elvey]

You can use 2 smaller ended ones. Just use the same hole for the two ends.
Dwight

 

[maxtherabbit]

I thought about doing that, but I already have an array with the requisite number of resistors. I think I will just install it halfway and run some ribbon wire to the other side