Datamisc's latest activity

http://15khz.wikidot.com/ Note that several NEC monitors do support 15KHz horizontal, even though the manual says it doesn't. And many...

Back in the early’80s, several software rental stores opened in Toronto. I remember that for a “regular “ rental you were only given...

Not sure if anyone is interested in this software, its rare and had it in a drawer since 1991 it was developed by Quaid Software...

Yes, monitors from that era always under scan by a fair amount.

Roger, did the degaussing, and the borders are straight. They dont fill all the screen, but i guess that is how it was maybe? Thanks...

Ok after your advice I checked that area, using magnifier glasses and found some cracks in the solder in a couple of components, applied...

I think you're over analyzing this. The fact that you have high voltage means the HOT is doing its job. There isn't much that could...

Ok, will check that out. Thank you

Ok will triple check with the oscilloscope and will analyze the schematics for that area. Thank you Burley..

So, this repair is not only to make the monitor work, but I also love to learn new things. I could not find the Horizontal Output...

Ok work has the best of me at the moment, but managed to do a fast modification to the G2 (285 v) and took a picture of the screen, will...

Will do that and post here my results. thanks

It's not a critical adjustment. Just turn it up and see if you get anything on the screen. If there's no difference, put it back where...

Interesting article, thank you Burley, will read it also tomorrow so my head gets all the important things.

Hey Andy, thank for the reply, I've read about desoldering the G2 wire and doing direct measures on it. Should I do that first or adjust...