Krille's latest activity

Still based on my BIOS, with even more text strings removed... Quite an original way to address my license/copyright complains Still ten...

I think we can all agree that life would have a been a lot easier if Michael Shrayer had had the foresight to design the original...

Yes, it does, actually. (Sorry Svenska.) The 386 builds includes MODULE_WIN9X_CMOS_HACK which attempts to create a dummy drive in CMOS...

RealDOOM is a port of vanilla Doom (forked from PCDoomv2, to be specific) made to run in Real Mode. (Coincidentally, another project...

Yes, CPU detection is easy, but that's not the problem. The CPU-specific code is almost exclusively there to reduce size, not to...

Finally got around to writing the image display routine for the EGA. Since the portable converts the colors to monochrome, I mapped that...

Thanks for the tips. Quite a eventful last few hours I tried RAYXTIDE and it's not detecting the card. I then tried the card on my IBM...

I was briefly tempted to necro this thread as it is the top google hit for "8088 prefetch algorithm", but I will be good and post a new...

I suspect that the ROM sockets on the OP's motherboard are sitting at addresses different to what the OP thinks they are.

I remember reading somewhere that some early implementation of ROM shadowing did move the range though I can't recall where I read that...

I found this in the other wiki "Hard disk emulation over serial port for PC XT clone using XTIDE"; This is news to me. As far as I...

I haven't found any thread that describes this subject in detail, so decided to write a small wiki that covers the whole process. And I...

I see. Well, if the HDD is the bottleneck it won't make much difference to enable ROM shadowing. BTW, have you tried using the drivers...

@MaximRecoil: To maximize performance, make sure ROM shadowing and caching is enabled for the XUB ROM segment.

Lots of info at https://xtideuniversalbios.org/ You can disable Slave detection in the XUB, Primary IDE Controller / Slave Drive and...