My Mitsubishi MP-3200 386 does not have an IDE controller onboard, but it has an Acculogic sIDE3+. The ROM on the sIDE3 is too old to detect the CF adapter I have, so I am working on XT-IDE.
I downloaded and built XT-IDE it from source, and found that the Motherboard has two slots for option roms I burned two eeproms, low/high, using ide-386, and was able to get to the the XT-IDE boot menu.
I already have a gotak and a floppy disk that can both boot to DOS 6.22.
When I see XT-IDE menu, it shows that the CF card is detected, but then stops. I can press A, C, F6 etc and have that option highlight on screen, but no other key seems to make it proceed with booting the selected option.
Am I missing something obvious, like a key combination or missing menu option? Or is this an actual problem I need to troubleshoot?
I downloaded and built XT-IDE it from source, and found that the Motherboard has two slots for option roms I burned two eeproms, low/high, using ide-386, and was able to get to the the XT-IDE boot menu.
I already have a gotak and a floppy disk that can both boot to DOS 6.22.
When I see XT-IDE menu, it shows that the CF card is detected, but then stops. I can press A, C, F6 etc and have that option highlight on screen, but no other key seems to make it proceed with booting the selected option.
Am I missing something obvious, like a key combination or missing menu option? Or is this an actual problem I need to troubleshoot?