VERAULT
Veteran Member
So I decided to pull this FULL SIZE AT tower out of my crawlspace and give the system a check. A few years back I removed the barrel battery before it got too bad. IT has some minor corrosion that I can address but not yet.
The system posts fine. Its got an intel 486 33mhz with WEITEK coprocessor and 8MB RAM (8 x 1MB 30 pin simms). comes with a western digital 16 bit ISA VGA card and an ESDI hard drive controller connected to a 1.2mb 5.25" drive, 1.44mb drive, tape backup and working Micropolis 1664-7 344mb 5.25" HDD. IT works and boots but has some bad sectors. The motherboard has "486 WB" stenciled on the back of the board near slot 3. I want to put this system in a new case as the full tower case front bezel and legs (plastic) are super brittle. And its too big.
So where can I find a small AT case (anything midtower or smaller would be ideal)?
The system posts fine. Its got an intel 486 33mhz with WEITEK coprocessor and 8MB RAM (8 x 1MB 30 pin simms). comes with a western digital 16 bit ISA VGA card and an ESDI hard drive controller connected to a 1.2mb 5.25" drive, 1.44mb drive, tape backup and working Micropolis 1664-7 344mb 5.25" HDD. IT works and boots but has some bad sectors. The motherboard has "486 WB" stenciled on the back of the board near slot 3. I want to put this system in a new case as the full tower case front bezel and legs (plastic) are super brittle. And its too big.
So where can I find a small AT case (anything midtower or smaller would be ideal)?