Search results

100 ohm

This is the easiest way to connect a gotek, a ready made adapter https://www.ebay.com/itm/325989439870

I could use more information on the schematic and part numbers. I am also using Kicad.

Do you have any more information on the schematic?

Is there any chance of getting a copy of that zip file? Thanks.

This is not mine but check here...

On the board there is the name and possibly the part number. They are not clear in the pictures.

What is the part number and company name on it?

Have you saved the software so that it is never lost? It would be nice to reverse engineer that board.

That is different than what I have.

The Drive C is by design to become the A: drive. It loads the software to the Drive C and you then can use the B: and newly changed designation C: to work from. Yes both of the drives still work.

I think I have the only known copy of the Drive C software for the Executive. I did not have a copy of WordStar to finish the software install on the Drive C, but it did set the Drive C up as A: and changed A: to C:. The software is uploaded to the Osborne Computer Group right now!

$76.00 Shipped. DM me.

Look at the kit on Ebay and let me know if you want it.

I have not, Ebay is just easy. I would have to figure out how to sell otherwise.

I will have a mechanical keyboard replacement kit back on ebay this weekend. I am putting the kits together. Stay tuned.

Ebay has one ready to go.

I would like to have a copy of the ROM. There are some adapters on Ebay ready to use with the Gotek

The only other solution to have a modern mechanical keyboard is a kit that is on Ebay, if this is what you mean?

You just need to solder it across the 2 jumper pads. It is just like using a bodge wire between 2 pads.