jmdhuse
Experienced Member
Hello All,
I have a Camintonn CMV-1000 1MB memory board that I picked up at a good price, expecting that it might have a few problems (it does). I can't find documentation for it, and so I suspect that some of my problems are due to start/end address switch settings.
Does anyone have this board properly operating in their system? If so, would you post a photo of the switch settings and let me know what address range it is mapped to? I think that if I had confidence that my switch settings were correct I would have more success in debugging the rest of it.
Physically, it looks a lot like the MSV11-QA etch revision A board, but I'm not sure that the settings for the DEC board apply directly to the CMV board...
Thanks, Jon.
I have a Camintonn CMV-1000 1MB memory board that I picked up at a good price, expecting that it might have a few problems (it does). I can't find documentation for it, and so I suspect that some of my problems are due to start/end address switch settings.
Does anyone have this board properly operating in their system? If so, would you post a photo of the switch settings and let me know what address range it is mapped to? I think that if I had confidence that my switch settings were correct I would have more success in debugging the rest of it.
Physically, it looks a lot like the MSV11-QA etch revision A board, but I'm not sure that the settings for the DEC board apply directly to the CMV board...
Thanks, Jon.