Hal9000
Experienced Member
Hi all,
I recently found a deal on an Epson-LQ1070+. However it, was sitting in a warehouse for a few years and had another slightly heavy computer accessory sitting on top of the paper guide and dust cover. This has caused the two parts form a concave "Bow". They still fit, but they are curving a bit closer to the roller and print head than I'd like. Has anyone ever straightened out bowed plastic i.e. heat, bake, heat gun etc? What is a good way to reverse the bowing and make them straight again?
Thanks for the help.
I recently found a deal on an Epson-LQ1070+. However it, was sitting in a warehouse for a few years and had another slightly heavy computer accessory sitting on top of the paper guide and dust cover. This has caused the two parts form a concave "Bow". They still fit, but they are curving a bit closer to the roller and print head than I'd like. Has anyone ever straightened out bowed plastic i.e. heat, bake, heat gun etc? What is a good way to reverse the bowing and make them straight again?
Thanks for the help.