• Please review our updated Terms and Rules here

installing a DF0 selector in an amiga 2000

oblivion

Veteran Member
Joined
Aug 28, 2010
Messages
981
Location
Scottsdale, AZ
ok, so I bought a DF0 selector off AMIGAstore.eu some time ago to install in my amiga 2000 so I could select between my internal floppy drive and an external floppy emulator (to keep the origional look on the desktop). The instructions I found seem to be for an Amiga 500 where your supposed to install the selector where the "EVEN CIA" chip is located. no chip is labled EVEN CIA on the A2000 board so i'm unsure which of the two chips to replace. I suppose I could do this by trial and error since its one one of two chips but if anyone knows is it the one on the right or the left?

20190402_151648.jpg
 

Zippy Zapp

Experienced Member
Joined
Dec 13, 2014
Messages
206
Location
USA:CA
One of the CIAs goes to the External Floppy Port while the other one can be traced to the serial and parallel ports. I can't tell which one that is in the picture there. But maybe you can trace the port traces and see?
 
Top