JoJo_ReloadeD
Experienced Member
- Joined
- May 12, 2007
- Messages
- 120
I've just been given a Juko EMS board to use on a PC/XT clone.
It has a ISA 16 bit connector, but it can work in 8-bit mode according to this page:
http://www.student.nada.kth.se/~d94-tan/pckort/jukoems.txt
That's the only info about the board I could find. I had it filled with the maximum 6mb that can hold.
I tried these drivers with it, but with no luck:
- AST Rampage (remm.sys, 3.10 to 4.50)
- Intel (emm.sys)
- AT&T (aemm.sys)
All of them say that no EMS board is present.
Do anybody know of a driver that can work with this board?
EDIT:
A photo of the board:
It has a ISA 16 bit connector, but it can work in 8-bit mode according to this page:
http://www.student.nada.kth.se/~d94-tan/pckort/jukoems.txt
That's the only info about the board I could find. I had it filled with the maximum 6mb that can hold.
I tried these drivers with it, but with no luck:
- AST Rampage (remm.sys, 3.10 to 4.50)
- Intel (emm.sys)
- AT&T (aemm.sys)
All of them say that no EMS board is present.
Do anybody know of a driver that can work with this board?
EDIT:
A photo of the board:
Last edited: