Roe
Experienced Member
I'm (finally, thanks sgutils) installing RSTS/E 10 on my pdp11/93, and I'm having trouble getting it to recognize a DHQ11.
A brief inventory:
11/93, 4MB, with 8 DL11s (console at 777560, 7 more starting at 776500 vector 300)
CMD CQD220A/TM SCSI controller at 772150
RQDX3 at 760334
DEQNA, standard settings
RLV21 RL02 controller, standard settings
DHQ11 at 760440, vector 400
The DHQ is in DHU11 mode, as recommended, and all the hardware works. Unix sees and runs it all perfectly.
RSTS does not recognize the DHQ. Even during the installation procedure, it didn't ask about dh-style controllers.
The default vector for a DHU/Q at 760440 is 300, which I obviously had to change to make room for the 7 DH11s. I picked 400 since it was a simple change on the dip switches, but I suspect RSTS wants some kind of standard vector for the card.
Anyone have any pointers?
Thanks in advance.
A brief inventory:
11/93, 4MB, with 8 DL11s (console at 777560, 7 more starting at 776500 vector 300)
CMD CQD220A/TM SCSI controller at 772150
RQDX3 at 760334
DEQNA, standard settings
RLV21 RL02 controller, standard settings
DHQ11 at 760440, vector 400
The DHQ is in DHU11 mode, as recommended, and all the hardware works. Unix sees and runs it all perfectly.
RSTS does not recognize the DHQ. Even during the installation procedure, it didn't ask about dh-style controllers.
The default vector for a DHU/Q at 760440 is 300, which I obviously had to change to make room for the 7 DH11s. I picked 400 since it was a simple change on the dip switches, but I suspect RSTS wants some kind of standard vector for the card.
Anyone have any pointers?
Thanks in advance.