RichCini
Veteran Member
All --
I tried a few things based on the above so I'm going to respond to several posts:
* I did rearrange the cards again to put the UC07 ahead of the SLUs. No change.
* The CPU is in HALT when doing the DMA load. I dumped memory and compared it to the listing above and it matches, so it's definitely loading to RAM.
* I tried "206G" rather than "200G" but it still printed the address and returned to the ODT. I also tried this with the CPU in RUN and it has no impact.
So, the code is definitely being loaded to RAM but not executing. Not sure where to go with this now.
I tried a few things based on the above so I'm going to respond to several posts:
* I did rearrange the cards again to put the UC07 ahead of the SLUs. No change.
* The CPU is in HALT when doing the DMA load. I dumped memory and compared it to the listing above and it matches, so it's definitely loading to RAM.
* I tried "206G" rather than "200G" but it still printed the address and returned to the ODT. I also tried this with the CPU in RUN and it has no impact.
So, the code is definitely being loaded to RAM but not executing. Not sure where to go with this now.