I am looking to get a set of case screws for one of my Tandy 1400 LT models. From the looks of it the screw major diameter is 3mm x 8mm length (after the head) so that's a metric M3 x 8mm?
They are metric screws 3mm thick by 8mm long, used my other 1400 to measure them.
Yes I know about your board, think you sent me one that didn't work in my units (sees the CF but does not boot).
I have a ton of machines and projects and it might take me years or more to get around to finishing one up (missing screws are low priority until it just bugs me).
No idea, I just wondered. The BIOS was built on the slightly later 1400FD which has V20 chip. Though, I know of at least one 1400LT that is working with it (with system BIOS 1.4 IIRC).
Now I'm intrigued as to the need for the screws, if it's not been opened!