I tried fixing the problem with a couple of zip ties and while it kinda works, I am unable to tighten the zip ties as much as needed. As a result, the mechanism doesn't lock up fully and lets go as soon as you release the lever. Maybe I'll try loctite next but since it's cracked on both sides...
i'm looking to buy two or four identical SIPP modules, 256K (set of four) or 1M (set of two or four) regardless, as long as they're cheap and located in the EU. I need them to test a 286 board.
Cheers
Last year I picked up a PCA-6003 single board computer from the recyclers along with the PCA-6108P4-C base board. I found that two 1000uF 10V capacitors on the card itself were bad so I replaced them. However, when I plug in an ATX power supply, the system turns on as soon as the PSU on/off...
Does anyone here have experience fixing floppy disk drives?
I have two 1.2MB 5.25" disk drives that are faulty. The Mitsumi's head moves back and forth during boot but the spindle motor doesn't spin. I can move it by hand no problem. The second drive is a Teac FD-55GFR and this one also...
Hey guys,
I don't really know where to post it, here or in Tech. Support but here goes.
I bought the abovementioned computer knowing that there's some kind of a problem with the LCD. Received it today and can confirm that the LCD backlight turns on but the screen is all white. However, the...
A few days ago I picked up a PCA-6003 single board computer from the recyclers along with the PCA-6108P4-C base board. I found that two 1000uF 10V capacitors on the card itself were bad so I replaced them. However, when I plug in an ATX power supply, the system turns on as soon as the PSU on/off...
Hi all,
I picked up a nice Toshiba Satellite 2100CDS laptop about a year ago at the flea market. It works but a horrible DSTN screen. I know Toshiba also sold laptops with TFT screens marked CDT so the question is, can I just swap out the screens between models?
Mine has a 400 MHz AMD K6-2, a...
I'm trying to test a SQ3270A disk drive on a socket 7 motherboard. I connected the drive as secondary master and jumpered it accordingly. Autodetect correctly identifies it as SQ3270A. Now for the problem. I have four 270MB disks and the drive acts the same with all four. It spins up then goes...
Hi guys,
I have an enigma on my hands. Since I'm lacking a proper EGA monitor, I'd like to test this EGA card with a monochrome monitor (NEC JB-1285DE).
The problem is, I don't have the manual and I can't find the dip switch settings anywhere online. Can anyone help?
Cheers
SainT
Hi,
I recently pulled the drive from storage only to find out that it doesn't work. When I try to access the drive I get "General failure reading drive B:".
I cleaned both, the rails and the heads. During boot, the LED does light up and I can see the head move correctly back and forth all the...
I gave up and stuck the chip in a programmer, erased it, wrote the V20 ROM with "Skip Write 0xFF" unchecked. I tested this in my XT and it works when there's no CF card present. It correctly detects Not found for both Master and Slave and proceeds to boot from a floppy. When I insert a compact...