bitfixer
Veteran Member
Hi all,
I recently made a little board to bring the video signal from a PET to an RGB2HDMI board, using a custom profile on the device. Currently this works on a homebrew protoboard, but will get the pcbs in a few days. It uses a single 74LS02 to combine the vsync and hsync into a composite sync signal, and the RGB2HDMI seems happy with that. It may be possible to use separate sync directly, but in my experiments I was not able to get that working so went down this route. It uses the video signals from the user port. Also currently should work on any 2001 or 2001-N, so far I have not gotten it to work with an 8032, but may be possible.
If anyone is interested in one of these (experimental) boards happy to send one to you. Requires a single 74LS02 dip, edge connector, and some jumpers.
I recently made a little board to bring the video signal from a PET to an RGB2HDMI board, using a custom profile on the device. Currently this works on a homebrew protoboard, but will get the pcbs in a few days. It uses a single 74LS02 to combine the vsync and hsync into a composite sync signal, and the RGB2HDMI seems happy with that. It may be possible to use separate sync directly, but in my experiments I was not able to get that working so went down this route. It uses the video signals from the user port. Also currently should work on any 2001 or 2001-N, so far I have not gotten it to work with an 8032, but may be possible.
If anyone is interested in one of these (experimental) boards happy to send one to you. Requires a single 74LS02 dip, edge connector, and some jumpers.