Hello All.,
I am attempting to get a NIC working with a Tandy 1000 TL/3. My card is a 3com 509TP, I can verify that the card works in my 486 just fine, but no matter what I try with the 1000 it will not work, the configuration program says there are no free io addresses when I try the autoconfigure. The only other card in the system is a glitchworks xtide rev3, I believe it is at 0300h and it works perfectly. I have tried disabling the built in serial and parallel ports via setuptl3 and still no go.
Has anyone been able to successfully use this or perhaps another NIC in this machine?
Any assistance or information would be greatly appreciated.
Thank you
I am attempting to get a NIC working with a Tandy 1000 TL/3. My card is a 3com 509TP, I can verify that the card works in my 486 just fine, but no matter what I try with the 1000 it will not work, the configuration program says there are no free io addresses when I try the autoconfigure. The only other card in the system is a glitchworks xtide rev3, I believe it is at 0300h and it works perfectly. I have tried disabling the built in serial and parallel ports via setuptl3 and still no go.
Has anyone been able to successfully use this or perhaps another NIC in this machine?
Any assistance or information would be greatly appreciated.
Thank you