Twospruces's latest activity

No, little board changes that are fixes to problems get added in the factory after the pcb is built....those are barnacles. For your...

You must have a different hardware barnacle on there!

Here is a picture of 1 second during boot up. A13 seems to have a periodic nature to it that fits.

sounds like you have a good ram board now. you could try pulling the CMOS RAM (to reset contents). I guess the CMOS RAM is one are of...

I used 27C256. (in fact on all the eproms)

If you pull the memory card altogether and try to boot up, you should get an error at 0000 message. Try that, to see if at least that...

In the othrr thread, i said your roms were the same except the character rom. I suggest burning a character rom and dropping it in...

My machine takes maybe 10sec to complete memory trst and move on. I'm your case it is surely moving on to the world map screen. BOOT...

I`ve pretty much concluded my efforts to get this T1000XE working again. I`ve made a compromise that I`m quite happy with. I was able...

From recollection, no disk activity before ram test is complete and boot is selected.

If you get the world map you need to press the boot key. The service guide at minus zero degrees has the error messages.

Hi, Sometimes I run laplink and I get an actual error message from laplink. I don't recall the exact words, but along the lines of...

Good question. I have msdos 3.3, 5.0 and 6.22. All show basically the same behavior. I boot from a floppy, then try to run laplink...

the cable is known good; it works with norton commander! so, that's not it. I started to remember that Laplink does not like to run on...

Hi, I have a Pentium 4 box loaded with Windows 98, to act as a tweener. The W98 box is on my home network, and I want to use it to...