retrobecanes
Experienced Member
My KayPro is giving me only a very thin line in the middle of the screen when it turns on, as if the prompt to insert a disk in drive A was completely crushed. But despite that I can see part of that line that blinks (where the cusor awaits).
I have tried to adjust the image with the different pots on the CRT control board but nothing works. Then if I place another motherboard in that KayPro (one that works for sure), I get a single bright dot in the center of the screen, not even the line.
What could this be?
I have tried to adjust the image with the different pots on the CRT control board but nothing works. Then if I place another motherboard in that KayPro (one that works for sure), I get a single bright dot in the center of the screen, not even the line.
What could this be?