So I got the Xerox back together. I put a had drive in the second floppy bay for now , until I got the floppy drive restored and a SD ISA solution installed.
very cool thank you for the info krebizfan and unknown_k
I actually found a folder with info on all the 5 Gateways I have and there was paperwork for this AT case.
This computer was purchased in november 1989 and as a buyer you would get a typed and signed letter thanking for your business...
I have this very early Gateway 2000 , It looks like an IBM clone. But I can't find much on the internets about these models.
does anyone here know more?
1ST1 this is the ATD model 16 memory card I have. Note the missing memory IC's and the 20 year battery is missing.
And this is the second memory Card I have.
@chuck I set the dip in accordance to the list of the service manual. I believe to have two 360k floppy drives.
So switch 1 is on for 48...
1st1 the driver for the clock don't seem to load, I'll see if I can find them on c:. but I also can't edit the config or auto exec entries
Then there is this error... is that a wrongly set bios jumper?
I made the mistake thinking that just pulling the PAL would disable the video card. I made the jumper as per convoluted manual.
I have video for the first time. I swapped the 1.1 ROM for my 1.31 ROM and the picture got clearer
hen I boot with ROM 1.1 as well as with ROM 1.31 it says that there...
When i turn on the motherboard seems to do some request. up until the keyboard is initialized. And then stops for some reason.
I don't hear a start up bong , the screen does not get energized, neither do the floppy drives. The hard drive spots up and seeks . The Keyboard flashes , signaling the...
Hello I have issues with my CT-64 terminal. It seems that the vertical sync is out for some reason.
https://youtu.be/Q3re47AbHJk
I have replaced all components in the power supply. and several Capacitors and Resistors that seemed out on the CT-64 main board.
So far what I checked on the...
actually I have two of these microscope hard drives.
one shows error 0010- 'Code 2 - Interface chip diagnostic failure' and doesn't spin up
the other has error 1110- 'Code E - No hall transitions during spin-up' and doesn't spin up
I would like and try to get them running but need some help...
Hello everyone
I have several Mac pro's (2.1-3.1 and 5.1) and I also have some vintage powermacs (a G3 and a 7200/120) One mac has OS x 7.5.5 installed the other OS 8.1
Before I forget I also have a Macintosh M0001 (but more about that one later).
I would like to install some software (games ...