Hi Chris,
I am actually using a Floppy emulator, and just load the IMD files on it. This works well, but I have had no luck with the Xenix disks. It seems to read the images ok, then starts the process of loading Xenix, and then hangs after I believe it tries to find Xenix on the hard drive. I...
Hi Chris,
I did try the Xenix disks on Dave's site, but they don't work. It seems like they are looking for Xenix on the Hard drive, and then hang. I need to do a fresh install. The diagnostic and the M/PM disks work fine from his site.
If you find anything. Let me know. I appreciate it!
Rich
Anyone by chance have the Diagnostic disk for the 8000-10 machine? I need to get the hard disk going and I could really use that disk. I can provide floppies for a copy, or maybe someoen has the disk image? The images online that I have found are not for this system.
Thanks!
Rich
By chance does anyone have a Xenix boot disk or software for the Altos 586? I am also looking for the Users, or the Xenix manual for the Altos.
Thanks for any help!
I need to verify some hardware and another boot disk, does anyone have a copy of a working 5 1/4" or 8" disk that boots with a Cromemco DPU or XPU (68000 Version)?
Thanks!
Hi, I am looking for a copy of the version of Cromix that will work with the Cromemco S-100, 68000 DPU card. I believe it was called Cromix Plus. I can supply or replace floppies if needed.
Any help would be great!
Thanks!
Anyone know where I can get either CPM 2.2, or CP/M-86 System/boot disks on the Compupro 5 1/4" format? The CP/M-86 disk can be for the 8085/8088 CPU, or the 8086/8087 CPU.
Thanks!
Hi,
If anyone can help I would appreciate it. I am looking for the two roms (or 2716 eproms) for the SCC Z80 card from Cromemco. I could also burn my own if I had the listings. Does anyone have these ROMs, or perhaps the listings in a file?
Thanks!
Does anyone know the type of drive that will hook up to the Cromemco WDI Winchester controller. The board seems to work fine as far as DMA tests etc, but the next project would be to hook up a drive.
Thanks!
Anyone have, or know where I can get, a boot disk-CP/M for this machine. It has two single sided 5 1/4 floppies.
Thanks! Any help would be appreciated!
I need to get a CCS 2422 controller, does not have to be fully functional, also I am looking for the proms for a Cromemco SCC S-100 single board computer (3 proms with RDOS, and Control Basic)
If you can help and have any of these I would appreciate it!
Thanks!
Rich
858-335-7707
I am looking for a CCS 2422 S-100 controller board. If anyone has one and wants to part with it please let me know. It does not have to be in full working condition..
Thanks!
Rich