Postal Patron
Member
- Joined
- Oct 31, 2003
- Messages
- 32
I'd like to have more than one 1541 drive attached, but there is a hardware mod mentioned on Ch 9 page 40 of the 1541 Disk Drive book where it is mentioned that there is two jumpers that both or either have to be cut to make it a physically seperate drive. For instance, a "load '*',8,1" would provide a dir on drive 1, so cutting the first jumper would add 1 to the 8 (load '*',9,1), cutting the second jumper would add 2 to the 8 (load "*",10,1), and both would add three for a new command.
The Disk Drive book does not specify where the jumpers are. It just says, facing the front, it is in the left middle of the board, no interface number or pic or anything. Since the Commodore 1541 Disk Drive book is the authority on the planet for this piece of hardware, is there somewhere else which describes the exact loation of the jumpers and is there a way to make a non-permanant fix?
The Disk Drive book does not specify where the jumpers are. It just says, facing the front, it is in the left middle of the board, no interface number or pic or anything. Since the Commodore 1541 Disk Drive book is the authority on the planet for this piece of hardware, is there somewhere else which describes the exact loation of the jumpers and is there a way to make a non-permanant fix?